Sprinkler System

As you go over your layout, settle in on a plan for where to place your sprinklers. Avoid having your landscape sprinklers too close to your home, spraying onto your home.

You may want to consider installing planter beds along the edge of your house with their individual drip systems. image source In this manner you can position your sprinklers a t very least a minimal methods away from your windows and siding.

With your layout set, head down to your local hardware or backyard store and start selecting out your sprinkler heads. Most sprinkler assemblies come with tags that will tell you how much water pressure they need to operate efficiently.

Ask one of the valuable salespeople to look it up for you if they do not. Equipped with the understanding of what your home water pressure is, you can break that down into the number of sprinkler heads you can fit on one valve. You can typically fit twice as a lot of the little sprayers on one stage, as you can of the large, rotating sprinklers.

You can then buy your valves and timer based upon what you require. The timer does not have to be anything expensive. You will have to find it near the water source and some electrical power, unless you buy one that sweats off a battery, so keep that in mind when shopping.

The other part of your sprinkler system is the piping. All you need to figure out how much tubing you need is a tape step and the number of sprinkler heads.


At each sprinkler head, you will need a riser. The length of the riser will depend upon how deep your pipe is going to be laid and how tall your sprinkler head is.

You will likewise require a T at each sprinkler head, and elbows at the valves and any edges. You will need one line of pipe for each valve.

The best way to decide it out is to draw it out. Have somebody else look at it too. The most awful that could occur however, is this you may have to go back down to the hardware shop for a bit more.

Leave a Reply

Your email address will not be published. Required fields are marked *